" M U L T I -
A Q U A - S O F T " I N
S T A L L A T I O N
(Congratulations!
You have made a wise and healthy decision)
IT SHOULD TAKE YOU NO LONGER THAN 20 MINUTES TO DO YOUR
INSTALLATION
IF YOU HAVE ANY QUESTIONS REGARDING INSTALLATION, FEEL FREE
TO CALL.
1)
If possible, select a vertical pipe because of less "cavitation".
2)
It takes two factors to make the "Multi-Aqua-Soft" System work.
i)
Rapid flowing water (pipe creates the perfect containment)
ii)
Magnetic "Force-Field" (which acts on minerals in all fluids)
Each order will have the number of magnets you ordered plus pieces of
insulated copper wire and a "zip tie". Use longest wires with main or swimming pool and
shorter ones with water heaters. The zip tie makes is easier to hold the 2
or 4 magnets in place while wrapping the copper wire.
PLACEMENT
"MULTI-AQUA-SOFT" UNITS HAVE DIRECTIONAL ARROWS
THAT MUST BE PLACED IN THE DIRECTION OF THE FLOW OF WATER.
(MAGNETOHYDRODYNAMICS)
|
|
Illustration of
Placement of Two (2) Units.
|
Illustration of Placement of Four
(4) Units.
|
(Click drawing to Enlarge)
|
|
Copper Pipe Example
|
WATER MAIN - Incoming
water (generally located at house with a shut off valve).
TYPE OF PIPE:
- PVC (plastic); Copper; Brass or Stainless Steel.
Up to 1" pipe.
- 2 Units required. Place
Units across from each other.
- Galvanized iron pipe up to 1" diameter
- 4
Units required. Place across from each other.
Note: If there is no room to place the units opposite of
each other, place them in-line, spacing 4 inches apart. If necessary, you can go
around a corner, placing 4 inches apart.
|
|
Copper Pipe Installation Example |
WATER HEATER - Place on Outgoing
Pipe. (Incoming pipe generally has
a shut off valve so that the water
can be shut off to tank)
TYPE OF PIPE:
- PVC (plastic); Copper; Brass or Stainless Steel.
Up to 1" pipe.
- Galvanized iron pipe up to 1" diameter
Note: Generally a copper "flex" pipe is used as
it is easier to hook up the water heater in the first place with copper flex. |
|
NO PHOTO AVAILABLE |
SWIMMING POOL/SPA - Place 4 Units on the "out" pipe of the heater or
on the Return line to the Pool/Spa.
|
-
ALWAYS DOUBLE CHECK TO SEE THAT YOU HAVE FLOW ARROWS
POINTING IN THE DIRECTION OF THE FLOW OF WATER.
-
If you have a choice between a non-magnetic and a
magnetic pipe to install on, always select the non-magnetic pipe (copper; PVC
plastic; stainless steel), as they require less units to get the job done.
Galvanized Iron pipe takes twice the magnetic force. You can tell a magnetic
pipe if a magnet wants to grab.
-
All "Multi-Aqua-Soft" Units have self-adhesive
tape to help hold them in place until you secure them with zip ties.
All that you need for installation is a pair of pliers.
-
Always select a vertical pipe if possible. If not, use a
horizontal pipe.
-
"Multi-Aqua-Soft" magnetic system is correct
when Units repel each other.
Congratulations, you are now on the "cutting
edge" of 21st Century Technology!
Top
